Tooling Around

Updates  |  Home ➜ Taig Mill ➜ Headstock Stop
 Previous |  Next | Site MapContact
Page Display Preference

You can choose the type of page display you prefer. Whatever your choice, the site content is the same.

Refresh the page to see the effect of your change.




By using this site, you agree to the use of cookies, as described on the About page. That page also describes tracking and your personal information. You can dismiss this notice by acknowledging that you've read it.

Taig Mill – Headstock Stop

This picture tells the story. Unless you need to move the headstock mounting plate to its lowest position, two tapped holes are available to mount the headstock stop. As can be seen, should you loosen the headstock clamp without carefully supporting its weight, the stop will, well, stop it from falling.

There really isn't anything to say. This may be the simplest accessory on the site.

About
This is the desktop version.    More...